Adaptec ANA-62000 - Manual (Page 192)

D-2
DuraLAN Fast Ethernet NICs User’s Guide
Running the Diagnostics
From the Hard Drive
Use the following steps to run the Diagnostics utility from your hard
drive:
1 Make sure himem.sys and emm386.exe are currently in
config.sys and that files=30 is present.
If they are not, add the following lines to the top of the config.sys
file:
device=c:\dos\himem.sys
device=c:\dos\emm386.exe /noems
files=30
Type the path to the DOS programs if it is not found in c:\dos .
2 Create a directory for the diagnostics on your hard drive.
3 Copy all files in this directory to the new diagnostics directory
of the hard drive.
4 At the DOS prompt, type go_diags and then press Enter.
Note: The easiest way of testing a DuraLAN NIC is running
the Selftest.
From the Floppy Drive
To prepare a DOS diagnostics boot diskette, use the following steps:
1 Create a bootable DOS diskette.
2 Copy the DOS files himem.sys and emm386.exe to the diskette.
3 Copy all the files in this directory to the root directory of the
DOS boot diskette.
4 Start the system from the floppy diskette.
5 At the DOS prompt, type go_diags and then press Enter.