Adaptec ANA-62000 - Manual (Page 88)

8-6
DuraLAN Fast Ethernet NICs User’s Guide
3 In the Available Adaptec Ports box, click the available port to
add to the group, and then click Add.
4 Repeat step 3 for each additional port.
Note: You must assign the same connection type to
each port in the same group.
O PTIONAL . To remove a port from the group, click the
appropriate port from the Group Ports box, and then click
Remove
.
5 When you are finished configuring the group, click Apply.
6 To create another group, repeat steps 1 through 5.
7 If you want to rename a group:
a Select the default group name in the Group(s) list box.
b Type the new name.
c Click Apply.
8 When you are finished configuring all groups, click OK.
9 If SNMP is not set up on the computer, you will receive the
message below. Click OK.
Figure 8-4. This message may be ignored during this
installation.