Adaptec ANA-62000 - Manual (Page 151)

11-15
Duralink64 Port Aggregation for NetWare
Verifying Configuration
You should verify the current port configurations before saving
them to the server.
1 From the Main Menu, select View Configuration, and then
press Enter. The View Configuration screen appears.
Figure 11-28. View Configuration Screen
Figure 11-28 summarizes that currently five stand-alone ports
without configurations and one group named Marcom are
enabled.
1 Marcom is made up of three ports: Adptsf1, Adaptsf2,
and Adapts3. The IPX protocol is assigned to Marcom using
ETHERNET_802.2 as the frame type and 121212121 as the IPX
Network Number.
2 Press Esc to return to the Main Menu.
3 Continue to Copying and Saving the Configuration.
1
If the ports or group were disabled, [Disabled] would appear next to the port/group
name.
Duralink Port Aggregation Setup
< F1> Help ©
Netware Loadable Module
Interfaces
<ESC> to go back to the previous menu.
Copyright 1998, Adaptec Inc. < F10> Abort Setup
Adptsf4 P No Protocols Configured
Adptsf5 P No Protocols Configured
Adptsf6 P No Protocols Configured
Adptsf7 P No Protocols Configured
Adptsf8 P No Protocols Configured
Marcom G
Adptsf1
Adptsf2
Adptsf3
Protocol Frame Network IP Address
IPX E_802.2 121212121