Creating port aggregation groups, Creating port aggregation groups -6, Creating port aggregation group – Adaptec ANA-62000 User Manual
Page 142
11-6
DuraLAN Fast Ethernet NICs User’s Guide
Creating Port Aggregation Groups
After configuring ports, you may create Port Aggregation groups
using the following steps:
1
In the Main Menu, select Set Groups, and then press Enter.
2
In the List of Existing Groups box, press Ins to add a new
group.
Figure 11-5. This message appears the first time
you add a new group
.
1
3
Select the group, and then press Enter.
Figure 11-6. Group1 is the new group’s default name.
4
In the Group Configuration menu, select Add/Remove Ports,
and then press Enter.
Figure 11-7. Group Configuration Menu
1
If you are in configsf, this message appears only when no groups are found.
List of Existing Groups
List of Existing Grou
No groups currently exist
List of Existing Groups
List of Existing Grou
1. Group1
List of Existing Groups
Group Configuration
List of Existing Grou
Add/Remove ports
Set group name
Set group type
Display existing ports
Group Name
Group1
1. Group1