Adaptec ANA-62000 - Manual (Page 122)

10-4
DuraLAN Fast Ethernet NICs User’s Guide
Configuring the Ports
1 In the Main Menu, select Configure Ports, and then press Enter.
Figure 10-2. Duralink64 Failover Setup Main Menu
2 In the Ports screen, make sure you know which port names are
assigned to the actual ports on the NIC.
The port names (Adptsf1,
Adptsf2, etc) do not correspond to the physical PCI slot numbers on
the motherboard.
Figure 10-3. Ports Screen
< F1> Help ©
Netware Loadable Module
Main Menu
Configure Ports
Set Failover Pairs
Configure Protocols
View Configuration
Install Software
Uninstall Software
Use arrow keys to move, <Enter> to Select, <ESC> to Exit.
Copyright 1998, Adaptec Inc. < F10> Abort Setup
Adaptec DuraLAN NIC Installation 4.2
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default)
Autodetect (default) Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled 1 Adptsf1
2 Adptsf2
3 Adptsf3
4 Adptsf4
5 Adptsf5
6 Adptsf6
7 Adptsf7
8 Adptsf8
No. Port Name NIC Connection Type Status
ANA-62044/TX:[1]
ANA-62044/TX:[2]
ANA-62044/TX:[3]
ANA-62044/TX:[4]
ANA-62044/TX:[1]
ANA-62044/TX:[2]
ANA-62044/TX:[3]
ANA-62044/TX:[4]