Adaptec ANA-62000 - Manual (Page 177)

B-3
Troubleshooting Tips
Driver fails to load or
fails to recognize the
DuraLAN NIC Check the BIOS settings. Sometimes the bus
master is disabled by default; therefore,
enable the bus master.
Persistent problems with
an adapter card set to
IRQ 15. This occurs in Novell NetWare. Either
disable IRQ 15 or change the Adaptec
DuraLAN NIC to another interrupt. Please
refer to your Novell documentation.
System hangs at boot up. Make sure the DuraLAN NIC is seated
properly in the PCI slot.
Check your system vendor for the latest
BIOS.
LED does not light when
running autonegotiation
in the Diagnostics utility. Use a loop-back cable, see Diagnostics Loop-
Back Cable on page A-5.
Symptom Solution