Adaptec ANA-62000 - Manual (Page 67)

5-13
Duralink64 Driver Installation for Windows
Removing Previously Installed Drivers
This section provides instructions for removing the previously
installed DuraLAN Standard driver which is necessary if you are
installing the new Duralink64 driver included with your DuraLAN
NIC.
Windows NT 4.0
To remove the previously installed DuraLAN driver from a
Windows NT 4.0 platform, follow these steps:
1 Double-click My Computer.
2 Double-click Control Panel.
3 Double-click Network.
4 In the Network window, click the Adapters tab.
5 In the Network Adapters list, click the Adaptec DuraLAN NIC you
want to remove, and then click Remove.
6 When asked if you wish to continue, click Yes.
7 Repeat step 5 until all Adaptec DuraLAN drivers are removed.
8 When you are done, click OK.
9 Click Close to close the Network window.
10 Click Yes to restart your computer.
Note: When you restart Windows NT, a message may indicate
that at least one service failed to start. This message will not
appear after you add the new driver. Click OK.