Adaptec ANA-62000 - Manual (Page 113)

9-7
Duralink64 Standard Driver for NetWare
Assigning the Protocols
You can assign IP or IPX protocols to Failover pairs and stand-alone
ports.
Note: The IPX protocol supports all four frame types and
multiple frame types simultaneously. IP supports either
Ethernet_II or Ethernet_SNAP, but never both at the same
time.
1 In the Main Menu, select Configure Protocols, and then press
Enter
.
2 In the List of Ports box, select the port, and then press Enter.
Figure 9-7. List of Ports/Failover Pairs Box
3 In the List of Protocols box, select the protocol for the selected
Failover pair or port, and then press Enter.
Figure 9-8. List of Protocols Box
P = Stand-alone Port
List of Protocols
IPX
IP