Removing drivers, Removing the duralan standard driver, Removing drivers -12 – Adaptec ANA-62000 User Manual
Page 118: Removing the duralan standard driver -12
9-12
DuraLAN Fast Ethernet NICs User’s Guide
Removing Drivers
The following procedures are to be used if a new driver needs to be
installed to replace an existing driver.
Removing the DuraLAN Standard Driver
To remove the DuraLAN Standard Driver installed from Duralink
4.10, using inetcfg, use the following steps:
1
Insert the Duralink64 for NetWare Disk.
2
At the server prompt, type
load inetcfg
and press Enter.
3
In the Internetworking Configuration menu, select Boards,
and then press Enter. A list of NICs appears.
4
In the Configured Boards screen, delete all existing Adaptec
NICs drivers by selecting the NIC(s) and pressing Del.
5
When you are finished, press Esc.
6
In the Internetworking Configuration menu, select Manage
Configurations
, and press Enter.
7
To save changes, select Yes.
8
Press Esc twice.
9
To exit inetcfg, select Yes.
10
At the server console, type down and then press Enter.
11
Type
restart server
and then press Enter.
To remove the DuraLAN Standard Driver installed from Duralink
4.2, use the following steps:
1
Insert the Duralink64 for NetWare Disk.
2
At the server prompt, type:
load a:\Newserver\setupsf
and
press Enter.
3
Select Standard from the Adaptec Select Driver Window.
4
In the main menu select Uninstall software and press Enter.
5
In the Uninstall the Software box, select Yes end press Enter.
❒