Removing drivers, Removing the duralink64 failover driver, Removing drivers -17 – Adaptec ANA-62000 User Manual
Page 135: Removing the duralink64 failover driver -17
Advertising
10-17
Duralink64 Failover for NetWare
Removing Drivers
The following procedures are to be used if a new driver needs to be
installed to replace an existing driver.
Removing the Duralink64 Failover Driver
To remove the Duralink64 Failover Driver use the following steps:
1
Insert the Duralink64 Drivers For Netware diskette.
2
At the system console prompt, type load a:\nwserver\setupsf
and press Enter.
3
Select Failover from the Adaptec window.
4
In the Main Menu, select Uninstall Software, and press Enter.
5
In the Uninstall the Software box, select Yes and press Enter.
6
In the Main Menu, Press Esc to exit setupsf.
❒
Advertising
This manual is related to the following products: