Adaptec ANA-62000 - Manual (Page 155)

11-19
Duralink64 Port Aggregation for NetWare
Removing Drivers
The following procedures are to be used if a new driver needs to be
installed to replace an existing driver.
Removing the Duralink64 Port Aggregation
Driver
To remove the Duralink64 Port Aggregation Driver use the
following steps:
1 Insert the Duralink64 Drivers For Netware disk.
2 At the system console prompt, type load a:\nwserver\setupsf
and press Enter.
3 Select Port Aggregation from the Adaptec window.
4 In the Main Menu, select Uninstall Software, and press Enter.
5 In the Uninstall the Software box, select Yes and press Enter.
6 In the Main Menu, Press Esc to exit setupsf.
❒