Configuring the standard driver ports, In windows nt 4.0 and 3.51 -2 – Adaptec ANA-62000 User Manual
Page 70
6-2
DuraLAN Fast Ethernet NICs User’s Guide
Configuring the Standard Driver Ports
in Windows NT 4.0 and 3.51
In the Adaptec New Hardware Found window, each port is
assigned to Autodetect, the default connection type that will always
detect port connection and negotiate a compatible speed and
transmission mode.
Note:
If you are required to insert the Windows NT CD, you must
re-install the latest version of the Microsoft Windows NT Service
Pack, and then restart the system.
1
In the Adaptec New Hardware Found window, make sure all the
DuraLAN NIC ports appear.
Figure 6-1. This window identifies each port’s PCI bus and PCI slot
2
In the New Adaptec NIC Port(s) Available for DuraLAN NIC box,
click the appropriate port.
3
In the Connection Types list, click the connection type for your
network or use Autodetect Default Connection. For descriptions,
see Connection Types on page A-2.