Agilent Technologies HSSI WanProbe J3916A - Manual (Page 42)

Local Terminal Configuration
Using the Main Menu
22
Modify/View Configuration Values
To configure items in the Modify/View Configuration Values menu:
1. On the Main Menu, Press 1, Modify/View configuration values. You see
the Modify/View Configuration Values menu.
2. Press a number to select a field and then type the corresponding values
necessary to configure the probe to operate on your network.
Autodiscovery Press 1 and then type the autodiscovery echo interval, in
Echo Interval seconds (optional). This parameter sets the time interval the
probe uses to transmit the autodiscovery frame used by HP
OpenView to maintain the network map.
The default value is 30 minutes (1800 seconds). A value of
zero results in no autodiscovery frame transmission.
Modify/View Configuration Values Menu - Firmware Rev
Memory configuration x Mbytes
[1]Autodiscovery Echo Interval (sec.) 1800
[2]Date Wed 05/05/98
[3]Time 09:12:00
[4]Time zone PST8PDT
S.Save changes and exit
0.Cancel changes and exit
Figure 2-3: Modify/View Configuration Values Menu