Agilent Technologies HSSI WanProbe J3916A - Manual (Page 83)

Installation
Connecting the Probe
63
If you use the network to configure the probe, make the network connection (refer
to “Connecting to the Network (Out-of-Band)” on page 49) and then refer to your
NetMetrix documentation to configure the following probe parameters:
z Serial Port IP Address
z Serial Port Subnet Mask
z Serial Port Speed
z Hardware Flow Control (if unsure, consult your modem’s documentation)
z Modem Init String
If you use an ASCII terminal to configure the probe as described in “Probe
Configuration Using a Local Terminal” on page 17, attach the terminal and
configure the following probe parameters:
z Serial Port IP Address
z Serial Port Subnet Mask
z Serial Port Speed
z Hardware Flow Control (if unsure, ask your local network administrator)
z Modem Init String
The Serial Port IP Address must be on the same IP subnet as the management
station’s serial IP address.
Normally, each company has one subnet mask that is used for all machines on
their network. Enter this subnet mask value into the Serial Port Subnet Mask
field. The Serial Subnet Mask used for the probe should match the subnet mask
used for the SLIP port on the management station.
Set the Serial Port Speed to a value that is less than or equal to the maximum
speed at which your modem can operate.
Set the Hardware Flow Control to Off (On is the default), unless you are using
high speed modems (14.4K baud or faster) with advanced features, such as error
correction and data compression. If the Hardware Flow Control is set to On, you
can set it to Off by using the probe’s menu or over the network from a NetMetrix
management station (refer to your NetMetrix documentation for details).