Modify/view security values, 1] allow packet capture, 2] allow tftp firmware downloads – Agilent Technologies HSSI WanProbe J3916A User Manual
Page 44: 3] allow packet generation, 4] allow duplicate and changed ip checking, Figure 2-4: modify/view security values menu, Bootp server setup on an hp or sun system
Local Terminal Configuration
Using the Main Menu
24
Modify/View Security Values
To configure security values for probe access, you use the Modify/View Security
Values menu.
1. On the Main Menu, press
2
, Modify/View security values. You see the
Modify/View Security Values menu (Figure 2-4).
2. Press a number to select a field and then type the corresponding values
necessary to configure the probe to operate on your network. See “Access
Security” on page 8 for more information on security.
Allow Packet
Press
1
and then type
Yes
to allow or
No
to not allow
Capture
packet capture.
Allow TFTP
Press
2
and then type
Yes
to allow or
No
to not allow
Firmware Downloads
TFTP firmware downloading.
Modify/View Security Values Menu - Firmware Rev
[1]Allow packet capture
Yes
[2]Allow TFTP firmware downloads
Yes
[3]Allow Packet Generation
Yes
[4]Allow duplicate and changed IP checking
Yes
S.Save changes and exit
0.Cancel changes and exit
Figure 2-4: Modify/View Security Values Menu