Agilent Technologies HSSI WanProbe J3916A - Manual (Page 53)

Local Terminal Configuration
Using the Main Menu
33
HSSI WAN Interface Configuration
Use the following procedure to configure the HSSI WAN Interface:
1. On the Main Menu, Press 3 , Modify/View Interface Values. You see the
Modify/View Interface Values menu (Figure 2-7).
2. Press a number to select a field and then type the corresponding values
necessary to configure the probe to operate on your network.
Modify/View Interface Values Menu - Firmware Rev
Interface Type HSSI
[1]Port 3.1 HSSI
[2]Port Type Monitor-only
[3]Data Sense Normal
[4]Link Type Frame Relay
[5]Clock Speed 52 Mb
S.Save changes and exit
0.Cancel changes and exit
Figure 2-7: Modify/View Interface Values Menu (HSSI WAN)