Agilent Technologies HSSI WanProbe J3916A - Manual (Page 50)

Local Terminal Configuration
Using the Main Menu
30
2. Press a number to select a field and then type the corresponding values
necessary to configure the probe to operate on your network.
Port Press 1 and then press the number of the Token-Ring port to
display the Token-Ring port configuration parameters along
with the current settings. The port number for the Token-Ring
interface (if installed) depends on where it is installed. Refer
to “Display Interface Summary” on page 36 for information
on port types and port numbers for the installed interfaces.
You can then view or configure the Token-Ring port
configuration parameters.
Modify/View Interface Values Menu - Firmware Rev
MAC Address 00 00 C6 XX XX XX
Interface Type Token Ring
[1]Port 3
[2]Port Type Telemetry
[3]IP address 0.0.0.0
[4]Default gateway IP address 0.0.0.0
[5]Subnet mask 0.0.0.0
[6]Token Ring Speed (Mbps) 16
[7]Ring Number -1
S.Save changes and exit
0.Cancel changes and exit
Figure 2-6: Modify/View Interface Values Menu (Token Ring)