Bootp server configuration – Agilent Technologies HSSI WanProbe J3916A User Manual
Page 92
Advertising
Bootp Server Configuration
72
Bootp Server Configuration
This chapter describes how to use the Bootp server method to configure the
Agilent J3916A HSSI WanProbe so that it can communicate over the network.
This chapter assumes that you have already installed the probe, but have not
attached the power cord. If you plan to use the local terminal method of
configuration, skip this chapter and refer to “Local Terminal Configuration and
Installation” on page 4.
The following sections are covered in this chapter:
z
“Probe Configuration Using a Bootp Server” on page 73
z
“Bootp Server Setup on an HP or Sun System” on page 75
z
“Bootp Server Setup on a PC” on page 79
z
Advertising