Agilent Technologies HSSI WanProbe J3916A - Manual (Page 94)

Bootp Server Configuration
Probe Configuration Using a Bootp Server
74
* Although bootp is supported on many versions of HP-UX and Solaris, the
NetMetrix application is only supported on specific operating system releases.
Refer to your NetMetrix documentation for the list of supported operating system
releases.
Item
Bootp Server Type
HP Sun PC
Model or Processor HP 9000
Model 700
or 800 Sun SPARC
Model 1, 1+,
2, IPC, 5, 10,
20 286 or above
Operating System HP-UX 9.x
or later* Solaris 2.1 or
later* DOS 3.0 or later
Network Operating
System/Subsystem ARPA
Berkeley
Services Sun
Networking
Services
(Ethernet and
TCP/IP) Microsoft LAN
Manager 1.0 or later
-or-
Novell NetWare
environment, including
LSL.COM v1.2,
IPXODI.COM v1.2,
NETX.COM v3.1
or later
Floppy Drive Not
Applicable Not
Applicable 3.5-inch Floppy Disk
Drive
System Memory Not
Applicable Not
Applicable 10KB of free memory
to run the installation
process. 100 KB of free
memory to run
BOOTPD.
Table 4-1: Minimum Requirements for a Bootp Server