Agilent Technologies N9340A - Manual (Page 119)

SCPI Command Reference 6
N9340A User’s Guide 117
• When
ON at the completion of each trigger cycle,
the trigger system immediately initiates another
trigger cycle.
• When
OFF, the trigger system remains in an
“idle” state until CONTinuous is set to
ON or an
:INITiate[:IMMediate] command is received.
On receiving the
:INITiate[:IMMediate]
command, it will go through a single trigger
cycle, and then return to the “idle” state.
• The query returns 1 or 0 into the output buffer.
1 is returned when in a continuous measurement
state. 0 is returned when there is only a single
measurement.
Take New Data Acquisitions
:INITiate[:IMMediate]
This command initiates a sweep if not in a
measurement. If in a measurement, it triggers the
measurement. A “measurement” refers to any
function under the
MEAS key.
Note that the function is enable only when the
continuous is
OFF.
*RST State:
Continuous, or On
Key Access: [BW/SWP] > {Sweep}
Key Access:
[BW/SWP] > {Single Sweep}