Rana Systems Elite Series User Manual
Page 203
ELITE SERIES USER MANUAL ENHANCED DOS UTIL.
you ran FORMAT. Instead it will be the “others
drive depending upon the drive from which FORMAT
was ran.
For instance, if FORMAT was run from drive 1,
<d> would be 2. If FORMAT was run from drive 2,
<d> would be 1. If FORMAT was run from drive 3
(Elite Controller), <d> would be 4. And last
but not least, if FORMAT was run from drive 4,
<d> would be 3.
The reason which FORMAT shuffles the drive num-
ber is because it assumes your system diskette
is the one from which FORMAT was run, and there-
fore the obvious default would be the “other
drive.
If the drive number displayed is correct, simply
type (RETURN>. If you wish to use a different
drive, simply type the drive number without any
(RETURN> following it.
After you’ve entered a drive number, FORMAT will
ask:
TYPE OF FORMAT TO PERFORM (0-3)? <t>
0)APPLE DISK-II ( 35 TRACKS)
1)RANA ELITE ONE ( 40 TRACKS)
2) RANA ELITE TWO ( 80 TRACKS)
3) RANA ELITE THREE (160 TRACKS)
The <t> is the type for which the drive is
defined under the currently in use DOS.
FORMAT is requesting the type of format which
you wish it to perform. The format type can be
P a g e 9 - 6