Rana Systems Elite Series User Manual
Page 215
ELITE SERIES USER MANUAL
ENHANCED DOS UTIL.
destination drive, simply press the correct
number.
CLONE will allow you to specify the same drive
as both the source and destination drive. In
this case, CLONE will give you a change to
change diskettes during the copying process.
After the destination slot number question
comes:
DRIVE NUMBER (1—4)? <dd>
where (dd> is the default destination drive
number. Once again, <dd> will be used if you
just press <RETURN>. If <dd> is not correct,
press the correct number.
The last question is:
DISKETTE TYPE (0-3)? <dt>
where <dt> is the drive type you have defined in
the booted WS for the destination drive you
specified. This drive type number is just like
the table of numbers listed previously for the
source diskette type.
Just like with the source diskette type, CLONE
is asking what type of diskette the destination
diskette is to be and not what type of drive is
going to be used.
CLONE will not permit you to specify a destina-
tion diskette type which has a smaller capacity
P a g e 9 — 1 8