Rana Systems Elite Series - Manual (Page 98)

ELITE SERIES USER MANUAL CP/M ENHANCEMENTS
ple) rate, so that is all that should be listed
for now.
To change the setting for drive A: within that
system sitting out on the diskette in drive B:,
type (without <RETURN>):
B:=A:
What you’ve told PROFILE so far is that you are
interested in updating the CP/M system in drive
B: (“B:=”), and the change you wish to make is
to drive A: (“A:”). However, you’ve yet to
specify the change to be made. Remember that
drive type number you used back in FORMAT and
PROFILE? It’s time to type that again.
Example: If drive A: is going to be (in your
finished system) an Elite Two (in which case
drive B: should be an Elite Two right now), you
would want to type:
B:=A:2
If drive A: is going to be an Elite One, type:
B:=A:1
and last, but certainly not least (by about
500,000 bytes of storage), the Elite Three would
be:
B:=A:3
P a g e 4 — 3 1