Rana Systems Elite Series User Manual
Page 212
ELITE SERIES USER MANUAL
ENHANCED DOS UTIL.
DRIVE NUMBER (1-4)? <Sd>
where <Sd> is the drive number from which you ran
CLONE.
The also refers to the drive in which you will
he inserting the source diskette. You can
simply press <RETURN> if <sd> is correct. If
you wish to specify a different drive number,
press the new number.
After the source drive number, CLONE asks:
DISKETTE TYPE (0-3)? <st>
where <st> is the drive type which you have
specified (using PROFILE) for the source drive
you selected, as follows:
0 = Disk II
1 = Elite One
2 = Elite Two
3 = Elite Three
Although CLONE determines the default answer to
this question by looking to see how you have the
source drive defined under the currently booted
DOS, this question is referring to the source
diskette itself and not the drive.
CLONE places restrictions on both the source
diskette and the destination diskette according
to how the drive is defined under the booted
DOS. CLONE will not permit you to specify a
diskette type which has a larger capacity than
P a g e 9 - 1 5