Rana Systems Elite Series - Manual (Page 257)

ELITE SERIES USER MANUAL ENHANCED CP/M UTIL.
copy of CP/M only, and no change to disk copies
will be made. This in-memory change would be
temporary, and would no longer exist once the
system was fully rebooted.
If the “<u>:=” is specified, then the change
will be made to the CP/M system on the diskette
in the specified drive, and no changes will be
made to the in-memory copy of CP/M.
The seek speed parameter is also optional. If
it is left off, PROFILE will default to the
correct seek speed for the drive model type you
specified.
Apart from various “insert disk” and other such
instructional messages, PROFILE basically has
only one primary line it prints over and over
again to reflect any changes it applies or to
give a listing of current settings. A sample of
this single line message would be:
H:+Rana Elite Three, Medium Seek.
AABCCCCCCCCCCCCCCCCCCCDDDDDDDDDDDD
The first line is the message, the second is a
little added template to assist in the
explanation of the various sections on the
message (it’s not printed by PROFILE).
The “A” section of the message (refer to second
line) is the drive for which the information
applies.
P a g e 1 0 - 2 6