Barco CLM R10+ - Manual (Page 142)

13. Projector control
Level 1 Level 2 Level 3
Menu [Center]
Bar scale [Bottom]
Local LCD contrast
Language
English
Français
Deutsch
Español
Italiano
13.2 Projector address
Overview
• Individual projector address
• Common address
13.2.1 Individual projector address
About individual projector address
Before a projector, and only this projector, can be controlled via a remote control, an individual address must be entered in the
projector.
This individual projector address can then be used to control the projector via remote control or via a serial connection.
Next to an individual projector address, each projector has also a common address for group control.
How to set an individual address?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER.
3. Use the ▲ or ▼ key to select Projector address and press ENTER.
4. Use the ▲ or ▼ key to select Projector Address and press ENTER.
The edit projector address window opens.
5. Use the ▲ or ▼ key to select a new value
Or,
enter a new value with the digit keys on the remote control or local keypad.
6. Use the ◄ or ► key to select the next digit and repeat step 5.
7. When the desired address is entered, press ENTER to store that address. (image 13-1, image 13-2, image 13-3, image 13-4)
Image 13-1
Image 13-2
Image 13-3
138 R59770021 CLM R10+ 11/10/2010