Barco CLM R10+ - Manual (Page 145)

13. Projector control
13.3.3 RS422 termination
What can be done?
When the interface standard is set to RS422, the last projector in a line should be RS422 terminated (ON position). All others in the
line should be in the OFF position.
How to set
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER.
3. Use the ▲ or ▼ key to select Serial communication and press ENTER.
The serial communication menu opens.
4. Use the ▲ or ▼ key to select RS422 termination and press ENTER to toggle between [On] or [Off].
Default: [On] (image 13-15, image 13-16, image 13-17)
Image 13-15
Image 13-16
Image 13-17
13.4 Network
Overview
• Introduction to a Network connection
• DHCP setup
• IP-address set up
• Subnet-mask set up
• Default Gateway set up
13.4.1 Introduction to a Network connection
DHCP
Dynamic host configuration protocol. DHCP is a communications protocol that lets network administrators manage
centrally and automate the assignment of IP addresses in an organization’s network. Using the Internet Protocol, each
machine that can connect to the Internet needs a unique IP address. When an organization sets up its computer users
with a connection to the Internet, an IP address must be assigned to each machine. Without DHCP, the IP address
must be entered manually at each computer and, if computers move to another location in another part of the network,
a new IP address must be entered. DHCP lets a network administrator supervise and distribute IP addresses from
a central point and automatically sends a new IP address when a computer is plugged into a different place in the
network.
IP
Internet Protocol. The network layer of TCP/IP. Required for communication with the internet.
Subnet mask
A number that is used to identify a subnetwork so that IP addresses can be shared on a local area network.
R59770021 CLM R10+ 11/10/2010 141