Barco CLM R10+ - Manual (Page 25)

3. Physical installation
3.1.2 RCU rugged case installation
Only with optional rugged case kit which is part of the touring kit (R9861000).
Necessary tools
No tools.
Necessary parts
Touring kit
How to install the rugged case of the remote control ?
1. Slide the bottom of the RCU into the rugged case and then pull the top of the rugged case over the top of the RCU as illustrated.
(image 3-5)
Image 3-5
3.1.3 RCU XLR adaptor installation
Install the rugged case before installing the XLR adaptor. Vice-versa, remove the XLR adaptor before removing
the rugged case from the RCU.
Necessary tools
5 mm flat screw driver.
Necessary parts
XLR adapter (part of the touring kit)
How to install the XLR adaptor of the remote control unit ?
1. Push the XLR adaptor (C) upon the rugged case of the remote control unit as illustrated. (image 3-6)
Note: Ensure that the text of the XLR adaptor is on top.
2. Fasten the two screws (S) of the XLR adaptor. Turn each screw repeatedly one or two turns until both screws are tight.
R59770021 CLM R10+ 11/10/2010 21