Barco CLM R10+ - Manual (Page 37)

4. Stacking CLM projectors
4. STACKING CLM PROJECTORS
Stacking of CLM projectors is only possible with optional touring kit. See "Mounting optional Carry handle",
page 209 for more information.
Overview
• Stacking CLM projectors
• Aligning stacked CLM projectors
4.1 Stacking CLM projectors
Preparations
Install first a carry handle on the upper projector.
Install at minimum the 3 locking points on the lower projector or install a complete carry handle kit.
How to stack CLM projectors
1. Place the projectors on top of each other. Ensure that all three interlocking pins (A) match with their corresponding interlocking
sockets (B). (image 4-1)
Tip:
In case of stacking projectors for a ceiling mount configuration, first turn the projectors upside down before placing the
projectors on top of each other.
2. Attach the two projectors together by closing all three interlocking adapters as illustrated. (image 4-2)
3. Are these projectors stacked for a ceiling mounted configuration?
If yes, mount a safety cable from one side of the projector around the truss installation to the other side of the projector. Repeat
this for the second projector. (image 4-3)
B
A
Image 4-1
Stacking projectors
R59770021 CLM R10+ 11/10/2010 33