Ransburg DynaFlow User Manual - Manual (Page 46)

LN-9400-00.9
DynaFlow TM User Manual - Operation
42
Color Change Sequencer
The redesigned DynaFlow includes an optional
color change sequencer that controls the flush,
load, and color change sequences for each gun.
Each time a job number is loaded into a gun, the
flush and load sequences are downloaded to this
controller. (A color change sequence is simply
a flush sequence followed by a load sequence.)
F9: COLOR CHANGE
An optional color change sequencer may have
been included with the controller. If it was included,
the F9 key will indiacte as such. If the F9 key is
blank, your system does not have this option.
When this function is selected, the operator is first
prompted for the gun mumber they wish to view
or edit the sequence for, they are then prompted
for which Job Number they wish to view and/or
edit the sequences of, and last, they are asked if
they want to view/edit the sequence for flushing or
filling. (There is a separate flush sequence and
load sequence stored for every Job Number and
for every gun.)
Once the operator responds to the previous
prompts, a screen similar to the one on the previ-
ous oage appears.
This chart displays a simple 6 step sequencer
where the user defines how long they wish each
step to take and which valves or signals should
be energized at each one of those steps. There
are 6 steps for the flush cycle and 6 steps for the
load cycle. When a color change is desired, the
sequencer automatically runs the flush sequence
followed by the load sequence.