CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 103)

Configuring Main System 1
Note:
1. This feature must work with the recording mode of Motion Detection: click the Configure button
(No. 14, Figure 1-2), point to General Setting, select System Configure, click the Camera
Record Setting tab, check Rec Video, and then select Motion Detect (Figure 1-9).
2. If you have set up Motion Sensitivity and Mask Filter in the System Configure settings (Figure
1-9), note that the configurations of Advanced Motion Detection have priority over these settings.
89