CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 92)

78
9. When the PTZ is tracking, you can still control it to zoom in a desired area. Click the Zoom in
Object item and specify Idle Time (sec). Idle Time (sec) indicates the zooming duration in
seconds. If a target appears after the specified idle time, the PTZ will start tracking. If not, the PTZ
will remain on the zoomed place.
Figure 1-75
10. Click the Test button to check your settings. There are two major settings you have to observe in
the testing. 1) Tracking: Observe if the target showing in the defined detection region is being
tracked with a highlighted mask, and magnified automatically in the left screen. If not, increase the
sensitivity degree. 2) Zooming: Use the mouse to outline an object in the right screen, and
observe if it is magnified in the left screen clearly. If not, use the Live Tuning buttons to adjust
directions and the desired level of zooming.
11. Click OK in the lower of the window to save your settings of the tracking time, the idle time for
zooming in objects and the testing results.
Starting Object Tracking
After the above settings, you can start the object tracking application. Click the Configure button (No.
14, Figure 1-2), point to Video Analysis, select Object Tracking Application, and then click Object
Tracking Start to start the function.