CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 49)

Configuring Main System 1
[Alarm]
To set up the detection alarm, click the Alarm tab.
Figure 1-31
1. In the Choose Camera section, select a camera from the drop-down list for setup.
2. Define the detection regions and object size. See Step 2 in [Counter] section above.
3. In the Setting section, there are two kinds of alarm modes:
„ Alarm Mode 1: The detected object slightly crosses the border of the alarm region it is about
to enter.
„ Alarm Mode 2: The detected object is fully inside the alarm region it just enters.
After you select the alarm mode, select how you want the alarm to be triggered.
„ 1 →2 Alarm: When an object enters from region 1 to region 2, the event will be recorded as
“Intruder” in System Log for later retrieval.
„ 2 →1 Alarm: When an object enters from the defined region 2 to region 1, the event will be
recorded as “Intruder” in System Log for later retrieval.
4. In the Option section, you can mask the detection regions, select alarms and deal with
alarm-triggered events.
„ Enable Mask: Mask the defined detection regions.
„ Invoke Alarm: Activate the computer noise alarm when an object enters a defined region.
Click the button next to the item to assign a . wav sound file.
„ Output Module: Enable an installed output device when an object enters a defined region.
Assign the output module and pin number.
„ Never Recycle: When the item is checked, the alarm-triggered events won’t be recycled
even when disk space is full.
5. To test your alarm settings, click the Test button.
35