CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 340)

326
Setting Up the Connection
Remote View allows two connection methods, and each are set up as follows.
To set up modem connection:
1. Make sure modems at client PC and at sever PC are already setup. The system currently supports
only external modems.
2. Click the Network button on main screen and enable Modem Server from menu.
3. In the MultiCam Remote Viewer, click Preference and then select Configure Modem. Select the
network to use from drop-down list.
4. Click the Connect button from menu bar of Remote View, and then select Dial-Modem from
menu to bring up the Connect dialog box, as shown:
Figure 8-1 Making connection to GV system through dial-up connection.
5. In the Phone Dial field, type the telephone number you wish to use (this column memorizes 10
most recently used telephone numbers).
6. Enter a valid user ID and password, and then click the Make Call button. Messages should appear
in the Connect Status window when the connection is established, shown in Figure 8-1.
To set up TCP/IP connection:
1. Make sure both your client PC and the sever PC have access to TCP/IP network.
2. Click the Network button on main screen and enable TCP/IP Server from menu.