CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 429)

Useful Utilities
10
Allowing Remote Control at DVR
The network traffic of WebCam server can be controlled when the DVR permits the remote control
from the Bandwidth Control program by the following steps:
1. Click the Network button, and select WebCam Server.
2. On the General tab, select the Run Bandwidth Control server option. When this option is
enabled, on the Control Center Server option list, the “Bandwidth Control Service” is marked with
a check.
Connecting to a WebCam Server
1. Click Host on the menu bar, and select Connection. Or you can click the Connection button on
the toolbar. This dialog box appears.
Figure 10-64
2. To add a WebCam server to be connected to, click Add.
3. Type host name, IP address, user name and password of the WebCam server. Modify the port if
necessary.
4. Click OK. If the connection is established, the WebCam server shows up in the Host List.
5. You can add up to 10 WebCam servers by repeating above steps.
6. To stop the connection, select the host and click the Disconnect button.
7. Up to 5 users of the Bandwidth Control programs can connect to a single WebCam server for
network traffic monitoring. However, only one user has access to bandwidth settings. When this
user clicks the Give Up Control button, the user no longer controls the WebCam server.
Whoever clicks the Get Control button first has access to bandwidth settings. For bandwidth
settings, see Controlling a WebCam Server below.
415