CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 147)

I /O Applications 2
Latch Trigger
Instead of constant output alarm in N/O and N/C, the Latch Trigger option provides a momentary alarm,
and allows you to set the alarm duration.
Setting up Latch Trigger:
On the main screen, click the Configure button, point to General Setting, click System Configure,
click the I/O Device tab, and then check Latch Trigger. See the red square in this dialog box.
Figure 2-4
Application Example:
In the above scenario, Input 4 is set to N/O and Latch Trigger as well. When Input 4 is triggered:
z Camera 1 starts recording for 30 seconds and stops itself until the next input trigger (see the Rec
Video option).
z Computer Alarm sounds once (see the Invoke Alarm option).
z The output (Module 3, Pin 7) is triggered simultaneously based on the Latch Trigger mode (see
the illustrations below).
Following illustrations can help you understand different output signals (see Purple Square in the
above dialog box) working with the Latch Trigger option.
133