CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System User Manual
Page 268
254
Enabling UpnP in WebCam
1. On the main screen, click the Network button, select WebCam Server, and click the Server tab.
The Server Setup dialog box (Figure 6-2) appears.
2. Click
Detect UPnP. This dialog box appears.
Figure 6-12
3. Click Searching to search the UPnP-enabled routers.
4. If your server is installed with more than one router, select a desired one from the UPnP Router
drop-down list.
5. If you server is installed with more than one network adapter, select a desired one from the IP
Address drop-down list.
6. Click
Configure to automatically configure the communication ports on the router.
Tip: If you don’t use the default ports, modify the related ports in the Server Setup dialog box (Figure
6-2) and then click OK. Re-open the dialog box and follow above steps to configure your router.
Note: UPnP technology now is also available in other remote applications: Control Center, Center V2,
Remote Playback, Authentication Server, VSM and TwinDVR.