CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 32)

18
[Motion Detection]
Apply to all camera Adjust Sensitivity (Level 1-10)
Set mask color
Clear mask
Cut mask
Add mask
Adjust Sensitivity (Level 9-9.9)
Activate Noise Tolerance
Figure 1-12
„ Motion Sensitivity: There are 10 levels of sensitivity for motion detection. And there are further
sublevels from 9 to 9.9. The default value is set to 9.5. The higher the value, the more sensitive
the system is to the motion.
„ Mask Filter: Mask instructs the system to ignore movement within the masked area. Mask could
be applied to repetitive motion that should be ignored within the surveillance area, such as street
trees.
„ Noise Tolerance: This function reduces false alarms and unwanted recordings caused by
weather or light changes without changing video quality. The level of noise tolerance can be
adjusted. For details, see Video Noise Solutions later in this chapter.
[Monitor Control]
Apply to all cameras Recording Codec
Day-Night Recording Mode
Advanced Codec Setup
Alarm Type
Delay Time Setup
Delay Time Setup
Figure 1-13 Monitor Control Setup
„ Rec Video: Enable the recording function. Use the drop-down list to select the desired recording
mode: Motion Detect, Round-the-Clock or Day/Night.
For details on Day/Night mode, see Setting Up Day-Night Recording Mode later in this chapter.
~ Recording Codec: Select the method of recording compression for your video: Geo Mpeg4,
Geo Mpeg4-ASP, Geo H264 or Geo H264 V2.
GV Mpeg4-ASP: Provides a smaller compressed file size than Geo Mpeg4. Additionally, it
supports a number of advanced settings that allow experienced users to fine tune the
encoding process. For details, see Geo Mpeg4 (ASP) Advanced Settings later in this chapter.