Rockwell Automation 22-COMM-C ControlNet Adapter - Manual (Page 21)

Installing the Adapter 2-3
1. Remove power from the drive.
2. Use static control precautions.
3. Remove the drive cover.
4. Connect a ControlNet cable to the ControlNet network. See
Figure 2.2 for an example of wiring to a ControlNet network.
Figure 2.2 Connecting the ControlNet Cable to the Network
5. Route the ControlNet cable through the bottom of the PowerFlex
drive ( Figure 2.3 ), and insert the cable plug into the adapter’s mating
receptacle.
Connecting the Adapter to the Network
!
ATTENTION: Risk of injury or death exists. The PowerFlex drive
may contain high voltages that can cause injury or death. Remove
power from the PowerFlex drive, and then verify power has been
discharged before installing or removing an adapter.
ControlLogix Controller
with 1756-CNB/R
PowerFlex 40 or PowerFlex 400 Drives
(each with a 22-COMM-C ControlNet Adapter)
(optional redundancy)
ControlNet Network