Rockwell Automation 160-DN2 160-DN2 DeviceNet Communication Module FRN 3.xx - Manual (Page 15)

Publication 0160-5.18 - June 2003
Chapter
2
Quick Start for Experienced Users
Introduction This chapter can help you start using the Bulletin 160 DeviceNet
Communication module. If you have previously installed or
configured a DeviceNet network and are familiar with Rockwell
Automation DeviceNet modules and drives, this information can help
reduce installation and startup time. If you are uncertain, use the full
installation/configuring information beginning in
Chapter 3 .
We base the procedures listed in this chapter on the assumption that
you understand DeviceNet concepts and know how to program the
Bulletin 160 SSC drive. You should also be able to understand
electronic process control and interpret the ladder logic instructions
required to generate the electronic signals that control your
application.
Because it is a start-up guide for experienced users, this chapter does
not contain detailed explanations about the procedures listed. It does,
however, reference other chapters in this book where you can get
more information.
If you have any questions or are unfamiliar with the terms used or
concepts presented in the procedural steps, always read the
referenced chapters and other recommended documentation before
trying to apply the information.
The information contained in this chapter includes:
• What tools and equipment you will need.
• When to address, configure, and program the module.
• How to install and wire the Communication Module.
• System power-up procedures.
Required Tools and Equipment Have the following tools and equipment ready:
• small blade screwdriver
• DeviceNet configuration software or hardware device