Rockwell Automation 1391 USER MNL/DIGITAL AC SERVO DR - Manual (Page 4)

Chapter
1-5
Introduction
Manual Objectives This manual is meant to guide the interface, installation, programming and
troubleshooting of a 1391-DES Digital AC Servo Drive. The contents are
arranged in order from a general description of the drive to troubleshooting
and maintenance. To assure successful installation and operation, the
material presented must be thoroughly read and understood before
proceeding. Particular attention must be directed to the Attention and
Important statements contained within.
Important Information about this Manual
This manual has been prepared primarily to support this product in a single
drive application. It is a standard document that is intended to help the user
understand the individual operating characteristics and limitations of this
equipment including hazards associated with installation, programming and
maintenance procedures. Note the following points:
•
This equipment has been designed to meet the requirements of a
component drive in an integrated drive system.
•
While the potential hazards associated with the drive remain the same
when used in a system environment, it must be noted that special
considerations are to be given to characteristics of other peripheral
solid-state control equipment and the cumulative impact on safety.
•
Manufacturers and engineering groups responsible for specification or
design of electrical control equipment must refer to applicable industry
standards and codes for specific safety guidelines and interface
requirements.
•
In the actual factory environment, the user is responsible to ensure
compliance with applicable machine and operator safety codes or
regulations which are beyond the scope and purpose of this document.