Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 14)

2
Chapter
2-1
Serial Port Parameter Programming
Read and Write Restrictions
Serial Port parameter programming may be accomplished by using the
1336-MOD-E1 or 1336-MOD-G2 through the 1336-MOD-S1 Serial Port
Connector. Through the Serial Port Connector, all parameters may be
viewed (
Read ) while the drive is running. Eight of these parameters display
real-time events (such as present drive speed and output current) that
cannot be changed (
Written to ). An additional 15 parameters are used to
report drive status and operational codes that are not programmable. All
remaining parameters may be changed while the drive is running. With the
exception of Parameter 45 (which is programmable in 0.01 kHz
increments), the Serial Port allows all frequency parameters to be
programmed in 0.01 Hertz increments and all time parameters to be
programmed in 0.01 second increments. Refer to your MOD option
instructions for operation and setup.