Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 37)

Local and Serial Port Parameters
Firmware Version 1.01-3.01
Chapter 3
3-23
Parameters 32Ć35
Parameters 32 – 35 may be used to program up to three Skip Frequency
Bands. Each band establishes a range of frequencies at which the drive will
not operate. If the frequency source that is presently controlling the drive is
within the band, the drive output frequency will stay slightly above or
below the band until the frequency source changes to a frequency outside
the band. The drive will then ramp up or down through the band to the
desired frequency. Parameters 32, 33 and 34 are programmed for the center
frequency of the bands.
Parameter 32 Ċ Skip Frequency 1
Freq P R
P R Enter Hertz
0
250
250
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
Parameter 33 Ċ Skip Frequency 2
Freq P R
P R Enter Hertz
0
250
250
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
Parameter 34 Ċ Skip Frequency 3
Freq P R
P R Enter Hertz
0
250
250
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting