Parameter 81 -- soft start/stop enable, Parameter 82 -- amp limit fault enable, This parameter is currently not implemented – Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL User Manual
Page 69
Advertising
Local and Serial Port Parameters
Firmware Version 2.01-3.01
Chapter 5
5-6
Parameter 81 -- Soft Start/Stop
Enable
Freq
P
R
P
R
Enter
Off/On
0
1
0
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
This parameter is currently not implemented.
Parameter 82 -- Amp Limit
Fault Enable
Freq
P
R
P
R
Enter
Off/On
0
1
0
Read and Write
Units
Minimum Value
Maximum Value
Factory Setting
When enabled, exceeding the setting of Parameter 36 (MOPC) will cause a
drive fault (F36 –– Diagnostic Current Limit).
Advertising