Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 64)

5
Chapter
5-1
Local and Serial Port Parameters
Firmware Version 2.01Ć3.01
The remaining parameters — from 70 on up — are local and serial port
parameters that may only be accessed with Firmware Version 2.01-3.01.
Initial values for each parameter have been preset at the factory and are
listed in the following descriptions. Any interaction or preconditions
required for setting parameters are also included in the following
descriptions.
Parameter 70 -- Base Driver
Board Version
Freq P R
P R Enter Code
–––
–––
–––
Read Only
Units
Minimum Value
Maximum Value
Factory Setting
This parameter displays Firmware Version 3.01 located on the Base Driver
Board in decimal format.
Parameter 71 -- Control Board
Version Freq P R
P R Enter Code
–––
–––
–––
Read Only
Units
Minimum Value
Maximum Value
Factory Setting
This parameter displays Firmware Version 2.01 located on the Main
Control Board in decimal format.