Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 79)

9
Chapter
9-1
Local and Serial Port Parameter Settings
Firmware Version 1.01Ć3.01
Table 9 -- Parameter List for Parameters 0 to 50
Parameters 0 to 50 can be accessed through either the local or serial port.
Local
Programming Serial
Panel Port
Parameter Parameter Min/Max Min/Max Factory
Number Text Units Values Values Setting
0 PARAMETER MODE None 0/0 0/0 0
1 OUTPUT VOLTS Volts 0/575 0/575 0
2 OUTPUT CURRENT % of Rated Output Current 0/200 0/200 0
3 OUTPUT POWER % of Rated Output Power 0/200 0/200 0
4 LAST FAULT Code 0/37 0/37 0
5 FREQUENCY SELECT 1 Code 0/5 0/5 0
6 FREQUENCY SELECT 2 Code 0/5 0/5 0
7 ACCEL TIME 1 Seconds 0/600 0.00/600.00 5
8 DECEL TIME 1 Seconds 0/600 0.00/600.00 5
9 DC BOOST SELECT Code 0/1 0/12 2
10 STOP SELECT Code 0/2 0/2 0
11 DECEL FREQUENCY HOLD Off/On 0/1 0/1 0
12 DC HOLD TIME Seconds 0/15 0/15 0
13 DC HOLD VOLTS Volts 0/115 0/115 0
14 AUTO RESTART Off/On 0/1 0/1 1
15 FACTORY SET -- DO NOT CHANGE None 0/0 0/0 0
16 MINIMUM FREQUENCY Hertz 0/120 0/120 0
17 BASE FREQUENCY Hertz 40/120 40/120 60
18 BASE VOLTS Volts 115/575 115/575 460
19 MAXIMUM FREQUENCY Hertz 40/250 40/250 60
20 MAXIMUM VOLTS Volts 115/575 115/575 460
21 LOCAL RUN Off/On 0/1 0/1 1
22 LOCAL REVERSE Off/On 0/1 0/1 1
23 LOCAL JOG Off/On 0/1 0/1 1
24 JOG FREQUENCY Hertz .0/120 0.00/120.00 .0
25 ANALOG OUTPUT Code 0/1 0/1 0
26 PRESET/2ND ACCEL Code 0/1 0/1 0
27 PRESET FREQUENCY 1 Hertz .0/250 0.00/250.00 .0
28 PRESET FREQUENCY 2 Hertz .0/250 0.00/250.00 .0
29 PRESET FREQUENCY 3 Hertz .0/250 0.00/250.00 .0