Rockwell Automation 1203-GK5 DeviceNet Communications Module FRN 1.xxx-3.xxx - Manual (Page 18)

1-6 Overview
Required Tools and Equipment The tools and equipment required, depend on if you are using a
1203-GK5 module or 1336-GM5 board.
1203-GK5 Module
When unpacking the 1203-GK5 module, ensure that the contents of
the shipping box include:
• 1203-GK5 DeviceNet Communications Module.
• 5-pin and 10-pin plug-in connector.
• DeviceNet Communications Module User Manual.
To install the 1203-GK5 module, ensure that you have the following
tools and equipment:
• 35 x 7.5 mm DIN rail A.
• 1/8" flathead screwdriver.
• Appropriate cables for SCANport and DeviceNet connections.
Refer to the “Selecting Cables” section in Chapter 3, Installing
the 1203-GK5 Module or 1336-GM5 Board.
• A computer that is:
– Running DeviceNet Manager or RSNetWorx for DeviceNet.
– Connected to and communicating with the DeviceNet
network using an available computer to DeviceNet interface
such as a 1784-PCD card or a 1770-KFD adapter.
– Able to connect to a PLC or SLC.
– Running RSLinx.
– Running RSLogix5 (if using PLC) or RSLogix500 (if using
SLC).
Important: Refer to http://www.software.rockwell.com for more
information on these software products.