Rockwell Automation 1203-GK5 DeviceNet Communications Module FRN 1.xxx-3.xxx - Manual (Page 44)

4-6 Configuring a Scanner to Communicate with the 1203-GK5 Module or 1336-GM5 Board
When the device description has completed loading, the Create EDS
Stub dialog box reappears.
Figure 4.8
Create EDS Stub Dialog Box
6. In the Select Bitmap for this Device box, select an icon for your
product. In our example, we selected 1336.BMP because the
product that we are using is a 1336 PLUS drive.
Important: Click Browse to go to the C:\DNETMGR\RES directory,
where DeviceNet Manager loads icons during the installation.
7. In the SCANport Device Bitmap File box, select the
SCANPORT.BMP as an icon for the 1203-GK5 module or
1336-GM5 board. This becomes the default icon for future
1203-GK5 modules and 1336-GM5 boards.
Important: Click Browse to go to the C:\DNETMGR\RES directory,
where DeviceNet Manager loads icons during the installation.
8. Under Polled Connection, select Enable. An “X” appears.
9. Type 4 in the Input Size and Output Size boxes. Four bytes is the
default I/O size for products using a 1203-GK5 module or
1336-GM5 board.
10. Click OK. A DeviceNet Manager message appears.
Figure 4.9
DeviceNet Manager Message
8
9
7
6
10