Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 158)

DeviceLogix 9-35
1503-UM054C-EN-P – June 2013
Output bits/tags
Hardware Boolean Outputs
Net out A
This bit controls the status of the IntelliVAC Plus relay output A as
marked on the front panel of the module. Setting this bit closes the
relay output. Resetting the bit opens the relay output
Net Out B
This bit controls the status of the IntelliVAC Plus relay output B as
marked on the front panel of the module. Setting this bit closes the
relay output. Resetting the bit opens the relay output.
Network Boolean Outputs
Net Out 0/Reset All Faults
This bit is used to reset all faults on the IntelliVAC Plus module.
Setting this bit high momentarily will reset all the IntelliVAC Plus
module faults provided the stimulus causing the fault has been
corrected. Caution should be taken when using this feature.
Resetting a fault three times simultaneously without removing the
stimulus causing the fault will cause the system to enter a “lock”
mode which requires power to be cycled on the module in order to
resume normal functionality.
Net out 1, 2
These are generic bits which can be set at various points in the
control logic. These bits are part of the output table of the
IntelliVAC Plus and can be read by exterior devices such as a PLC in
order to give status indication as to the operation of the control logic.
Note there may be additional generic “Net Outputs” available
depending on the number of IB slave devices connected.
Net Out 3-7/ Interim 1-5
These tags are the output portions of the interim 1-5 dual function
tags. The output tags are connected to a stimulus in the logic circuit
and will cause their associated interim 1-5 input tags to change state
per the example and figure 9.18.
Net Out 8/Protection Status
This is the output portion of the Protection status dual function bit.