Rockwell Automation 1329I Integrated AC Drive/Motor, Series B FRN 3.X - Manual (Page 51)

Step 9 - Check the Installation 9-3
1329I-5.5 Integrated Drive/Motor — January, 2000
9.3.1 Rotating the Cover
Before rotating the cover, take the following precautions:
1. Turn off, lockout, and tag AC input power to the drive.
2. Remove the cover by loosening the four cover screws. Note that the display board
ribbon cable is designed to disconnect when the cover is removed.
3. Wait five minutes after disconnecting power and verify that DC bus voltage is
zero. See Figure 5.1 for the location of the DC bus test points.
4. Refer to Figure 9.2 and use the following procedure to rotate the cover:
5. Remove the display board ribbon cable from the display board. You will need to
insert a small screwdriver into the cable latch to release it from the board.
6. Insert the display board ribbon cable into the opposite side of the display board.
Push the cable in until it clicks. Verify the connection by lightly tugging on the
cable.
7. Rotate the cover.
8. Connect the display board ribbon cable together.
Position the cover and tighten the four cover screws. The tightening torque limit for the
cover screws is 1.3 - 1.7 Nm (11 - 15 in-lb). Verify that all four screws are securely
tightened before applying power.
Figure 9.2
Rotating the Cover